Give me your opinion on it , it’s my ak-47 airsoft gun i decided to try painting urban digital camouflage. Tell me wut you think: http://img42.imageshack.us/img42/8312/34233150748057290914111.jpg
The Vz. 58 is a 7.62mm beating rifle planned and manufactured in Czechoslovakia and customary into check in the late 1950s as the 7,62 mm samopal vzor 58 (“7.62mm sub machine gun model 1958″), replacing the vz. 52 self-loading rifle and the 7.62x25mm Tokarev vz. 24 and vz. 26 sub machine guns. The vz. 58 externally be similar to the Soviet AK-47 but is internally a completely different design based on a short-stroke gas piston.
History
Development of the weapon began in 1956; leading the plan was ruler engineer Ji?í ?ermák give to the Konstrukta Brno facility in the city of Brno. The sample, recognized as the “Košt?” (“broom”), was designed to assembly room the midway Soviet 7.62x39mm M43 cartridge, rather than the Czech 7.62x45mm vz. 52 round, used in both the earlier vz. 52 rifle and the vz. 52 light machine gun. The attack rifle go in examine in 1958 and over a time of 25years (until 1984), over 920,000 weapons had been produced, fielded by the prepared forces of the Czechoslovakia, Cuba and numerous other Asian and African state.
The weapon does not have a square rotating hammer but is striker-fired and the striker is a strengthen bar hollowed from one end rough throughout its total length to accommodate its own operating spring. At the open end of the striker, a plate is welded and there is a groove cut in each side of this to skip on the receiver show banister. This hammer-striker enters the unfilled bolt and drives a fully suspended firing pin forward with each shot.
The rifle uses a trigger device with a bar-type fire mode selector, which is also a manual protection against unintentional liberation. When the selector handle is sited in its rear spot (“1″—solo fire) the sear is halt and the left striker snare is swivel by the dis connector, which is depressed by the bolt hauler after each shot and is consequently disconnected from the striker catch. The onward surroundings of the selector lever (“30″—repeated fire) disables the dis connector, and the left striker hook meshes with the sear apparatus. The core (“safe”) scenery with the selector knob pointing vertically downwards, mechanically lowers the trigger bar and the dis connector so there is no connection between the trigger and the semi-routine sear which clutch the hammer. The rifle also has an internal well being, which prevents the weapon from discharging when out of battery. The accurate striker-hammer grapple disables the striker-hammer, and it can only be released by pulling the charging handle back and raising the weapon.
I have an ak 47 airsoft gun and want to know if I should get an 8.4v battery or a 9.6v. I currently have an 8.4v and im going to get a second battery.
I have an XL ak-47 airsoft gun (yes, I know it’s cheap but I just shoot around for fun) and I believe there may be a problem with its battery. It’s a 7.2V 700 mah battery charged with a 250 mah output charger. I charge it for around 3 hours but when I put the battery in and start shooting, it quickly stops. I was thinking maybe it was because of my charge time, possible battery leak, or a gearbox problem? The manual (Chinese/English) says that I should charge it for 8 hours but I don’t really trust that. Please help!
This was recently bought so I don’t really expect it to have any major problems. The first time I charged it took around 3 hours. It is a Ni-Cd battery.
Yeah i have an old ak 47 airsoft gun and i need some mags could any of you please give me some websites to visit and buy some mags?!?! it has a pretty much flat top with a nob that sticks out to push up on the bbs and a little slide thing to hold the bbs in. The area that goes in the gun is a square block about 1 1/4 inch long and the latch that holds the mag in is the same distance down. There is nothing else on the top of the mag. Please help me quickly I have a big airsoft war with my friends soon!!!!
There’s an AK-47 airsoft gun I found. It looks nice and sounds reliable. It didn’t state a brand, so I asked the seller, and they said "ukarms". I checked the UK arms website, and the only similar picture to it was of a "CM028", which is a good CYMA gun from what I hear. Is this the same company? I want to know if this is a good gun to get. Thanks.
It’s not the seller i’m worried about, it’s the gun. I’ll just show you.
http://cgi.ebay.com/Airsoft-WOOD-Metal-AK47-Electric-AEG-Rifle-Full-Auto_W0QQitemZ320296233451QQihZ011QQcategoryZ160919QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
http://ukarms.com/Auto%20Electric%20Gun%20(Metal%20Gear)/index.htm
The problem IS that I can’t tell which one it is, the details are vague.
I have an AK-47 airsoft gun and I want to buy a red dot sight. I don’t know if I have to buy a specific red dot sight made for the gun or if I can buy a random one and still have it work on my gun. Do you know? Thanks.
I need to find a good, cheap peak detecting charger for my UTG AK-47 airsoft gun.
It is 8.4V, 700 mAH and its output is 250 mA
I have a JG AK-47 airsoft gun and I am going to use a 9.6v battery with it in a battery pouch to get a higher ROF. So do I just open the gun take out the plastic bushings and put in metal ones? Also can someone recommend some metal bushings that would work nice with my AK-47?
ok so im thinking of buying a ak-47 airsoft gun with 280 fps. and i dont know if thats good for a assualt rifle, its spring. i am getting it to replace my mp5. and was wondering if that fps is pretty good
Hi I have a JG Matrix Mauri Compatible AK-47 airsoft Gun, I wanted to know if there was any video which I would be able to see how to disassemble the gearbox, put in a new piston, spring and gears and reassemble the gearbox
The ak-47 video on mechbox.com is not what I am looking for, I need a video on how to take the gear/mechbox apart and back together not take apart thre gun
I have an Ak-47 airsoft gun and It it is dirty on the inside. Is there a good way do clean it, or do I have to take it apart?
I want an AK-47 airsoft gun… i’m willing to spend up to 100 dollars (plus shipping) This is the specifications i want it to have:
- Semi/Fully auto gun
- Shoots at least 240 fps
- Battery/Charger included (if it has 1)
- Shoots .6 mm bb’s
-and mag that Holds atleast 100 bb’s?
where can i find a gun like that….?
If the price is over 100 i really dont care!
The main thing im looking for is the mag that Holds lots of bb’s
Please tell me a site that has a gun that meets the specifications!
10 points to the best answer
I want an AK-47 airsoft gun… i’m willing to spend up to 100 dollars (plus shipping) This is the specifications i want it to have:
- Semi/Fully auto gun
- Shoots at least 240 fps
- Battery/Charger included (if it has 1)
- Shoots .6 mm bb’s
-and mag/clip (whatever its called) Holds atleast 100 bb’s?
where can i find a gun like that….?
If the price is over 100 i really dont care!
The main thing im looking for is the clip/mag (whatever its called) Holds lots of bb’s
Please tell me a site that has a gun that meets the specifications!
10 points to the best answer
I just bought an Kracken AK 47 Airsoft Gun and I was wondering if can attach a scope or red dot sight to it.
I have a AK-47 airsoft gun. whenever i try to shoot it, it will shoot 1 bb and then starts dry-firing. it will not start shooting until i use my barrel cleaner. whenever i stick it in, i hear a click, and then it will shoot 1 bb, then dry fire again. nothing is wrong with my clips, because i have 2 clips, and i have used my friends clips too, and the same thing happens every time. its an AEG, not spring gun. i could really use some help. i appreciate any help.
Where can I get an 4 star AK-47 airsoft gun for and made of almost all metal. Also has to be compatable with a Tokyo Mauri airsoft magazine(clip)?
i was wondering how would i paint my ak-47 airsoft gun gold and make it really shiny too
Hi, i bought an ak-47 airsoft gun about 4 months ago and it worked fine. about 3 weeks ago i loaded up a clip and it jamed. it shot the 1st shot fine. then the next shots were shooting 2 at a time about 5 feet, or rolling out of the barrel. i lubed it useing (pure silicone lube) i cleaned it and it wasnt that dirty. it went through about 2000 rounds. i noticed that if i fill my clip all the way up it will jame but if i put like 10 BB’s in it it shoots about 8 of them fine. any thoughs on what i should do?
Why Weapons Aren't Enough to Keep Your Family Safe? Read More...
Which is the most effective home defense weapon for a home invasion:
Click Here
to learn about the pro's and con's of each as well as the biggest mistake all the "heavy artillery" guys make when choosing "terminator ammo"!
(Hint: It has nothing to do with "stopping power" but it's nearly as important to your family that you get this right! Not doing so could cost you a lifetime of grieving that no law-abiding family should suffer...EVER!) Read More...